Digitalzoom - Santec SPVM-20AC Bedienungsanleitung

Bedienungsanleitung / User Manual SPVM-20AC / SPVM-26AC / SPVM-32AC
5.4.7 IR-set
This is used to select the IR cut filter operation mode.
OFF:
AUTO:
EXT:
After the setting has been completed, press [ENT] to save the adjustments. After that press
the [PRI] key to go back to the main menu page.
5.4.8 Digital zoom
This is used to select the digital zoom and digital pan/title operation mode.
OFF:
ON:
After the setting has been completed, press [ENT] to save the adjustments. After that press
the [PRI] key to go back to the main menu page.
_________________________________________________________________________________
Downloaded from www.Manualslib.com
If you select this mode, the IR cut filter is switched off.
If you select this mode, the IR cut filter is at AGC-LEVEL: You can then select the
output by choosing the switch delay time of 1, 5, 10 ,20 ,30 ,40 ,50 or 60 sec.
If you select this mode, the IR cut filter is set to external signal.
If you select this mode, the digital zoom is switched off.
If you select this mode, the digital zoom is set to 2x. At the this mode, you can
move the "ZOOM POSITION" by using the [UP] and [DOWN] key.
manuals search engine
- 63 -