Digitalzoom - Santec SPVM-20ACM Bedienungsanleitung

7.4.7 IR-set
This is used to select the IR cut filter operation mode.
OFF: If you select this mode, the IR cut filter is switched off.
AUTO: If you select this mode, the IR cut filter is at AGC-LEVEL: You can then select the
output by choosing the switch delay time of 1, 5, 10, 20 ,30 ,40 ,50 or 60 sec.
EXT: If you select this mode, the IR cut filter is set to external signal.
After the setting has been completed, press the [LEFT] button to save the adjustments and to
exit.
7.4.8 Digital zoom
This is used to select the digital zoom and digital pan/title operation mode.
OFF: If you select this mode, the digital zoom is switched off.
ON: If you select this mode, the digital zoom is set to 2x. At the this mode, you can
move the "ZOOM POSITION" by using the [UP] and [DOWN] key.
After the setting has been completed, press the [LEFT] button to save the adjustments and to
exit.
_________________________________________________________________________________
Bedienungsanleitung / User Manual SPVM-20ACM / SPVM-26ACM / SPVM-32ACM
- 68 -