Operation - Elica SHY-S BL/A/60 Montage- Und Gebrauchsanweisung

Mounting
Before beginning installation:
• Check that the product purchased is of a suitable size for the
chosen installation area.
• Remove the charcoal (*) filter/s if supplied (see also relative
paragraph). This/these is/are to be mounted only if you want
lo use the hood in the filtering version.
• Check (for transport reasons) that there is no other supplied
material inside the hood (e.g. packets with screws (*),
guarantees (*), etc.), eventually removing them and keeping
them.
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must verify
suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take the
weight of the hood.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only.

Operation

Model with 5-key keyboard
To select the functions of the hood, simply touch the commands:
a.
Button to increase suction speed (power):
Suction speed (power) 1
Suction speed (power) 2
Suction speed (power) 3
Note: suction speed (power) 3 is timed, after approximately
5 minutes the hood returns to suction speed (power) 2.
b. Button to decrease suction speed (power).
c. Button ON/OFF hood
d.
Button ON/OFF lighting
e.
Button ON/OFF programmed switching off:
it programs switching off of the active suction speed (power)
after approximately 3 minutes.
Models with mechanical control panel
a. ON/OFF light switch
b. Speed 1/OFF switch
c.
2-speed selection
d. 3-speed selection
Models with knob
0
1
2
3
A
B
C
D
Control panel with 6 buttons
To select the functions of the hood just touch the commands.
Light key ON/OFF
Intensive speed selection key (suction power) -
duration 5 minutes: the hood sets this power and
at the end of the 5 minutes returns to the previous
setting.
High-speed selection key (suction power).
Medium-speed selection key (suction power) -
when flashing it indicates the need to wash or
replace the carbon filter. This signal is normally
deactivated. To activate the alarm, disable the
electronic by pressing the 0 button for 3 seconds.
15
OFF
Speed 1
Light OFF
Speed 1
Light OFF
Speed 1
Light OFF
Light ON
Speed 1
Light ON
Speed 1
Light ON
Speed 1
Light ON