Operation - Elica Lullaby@ Montage- Und Gebrauchsanweisungen

Operation

This product is designed to work with an Elica remote control,
either supplied with the product or purchased separately as an
optional.
To control the hood via remote control, the affiliation
procedure must be carried out.
CAUTION!
To begin, the hood must be disconnected and then
reconnected to the power supply and the affiliation procedure
must be carried out within the first minute of connection to the
power.
Read the instructions supplied with the remote control, which
provide detailed instructions on affiliation and correct use.
Remote control connection (if applicable)
Once the remote control has been connected, this will be
displayed on the hood:
both LEDs flash.
Indicator LED on hood
Note: the Speed 4 (and the Speed 5, where applicable) if
selected, will activate for a limited period of time after which
Speed 2 is automatically enabled.
Note: Using the remote control, delayed shut-down can be
programmed based on the aspiration speed (power) enabled
at that moment:
Speed 1 (low aspiration): 20 minutes
Speed 2 (medium aspiration): 15 minutes
Speed 3 (high aspiration): 10 minutes
Il led L2 sulla cappa lampeggia con il colore associato alla
velocità selezionata.
Note (for hoods with WiFi):
The ELICA CONNECT App allows advanced management of
the delayed shut-down function, follow the instructions in the
App.
Attention: in hoods with WiFi, the delayed shut-down function
can be managed via remote control only if the hood WiFi
function is not active.
WiFi
• WiFi configuration: Follow the instructions provided in the
ELICA CONNECT App for the WiFi configuration.
During the configuration procedure, the LED L1 of the hood
will light up to indicate the connectivity status (see "WiFi status
table" below)
To interrupt the WiFi configuration procedure, press key A on
the remote control for about 2 seconds when the LED L1 of
the hood is on and flashing quickly.
Once the WiFi function has been configured, if it needs to be
changed, hold keys A+B on the remote control for about 2
seconds to reset the WiFi parameters (the key turns off) and
repeat the configuration procedure.
• WiFi activation/deactivation: after the configuration, it is
possible to deactivate/activate the WiFi function. Press A for
about 2 seconds to deactivate/activate the WiFi function.
Deactivating the function does not cause the loss of the WiFi
parameters.
• WiFi status table
WiFi LED
hood (L1)
Light off
White light on
steady
Orange light
flashing fast
Orange light
flashing slowly
White light on with
short flashing light
Filter Saturation indicator lights
At regular intervals, the LEDs on the hood indicate the need to
carry out filter maintenance.
Note: The filter saturation signal is visible for a few seconds
when the hood is switched on; within this time, the saturation
indicator lights must be reset.
Flashing Green LED: carry out maintenance on the grease
filter.
Red flashing LED: carry out maintenance on the charcoal
37
Device connection status
WiFi not configured or off
WiFi connected
Attempt to connect to the
WiFi router
Attempt to connect to the
Elica cloud
Remote command being
received (e.g. engine
ignition or light turned on)