Virutex PEB200 Gebrauchsanweisung Seite 25

B
C
D
A
(Figure 9)
B
(Figure 10)
B
Máx. 10°
D
G
H
(Figure 11)
(Figure 15)
A
F
E
C
I
A
A
2. Edge exit (ONLY PEB250)
To control the height of the edges A (Fig. 9) as they exit, you
must adjust the exit guide B (Fig. 8) to the height of the edge
+ 0.5 mm, blocking it with knob C.
8.3 Adjusting the edge press
To control the gluing pressure for the edge, you must adjust
index A (Fig. 10) to the thickness of the corresponding edge,
using knob B. If using very rigid edges which need more pressure
on the edge, for example a 3 mm PVC edge, the index can be
set at 2 or 2.5. Never set the index above the thickness of the
edge, as it is very likely that this will not soak up the glue well
and the result will be poor quality work.
8.4 Inclined guide plate adjustment
Place the guide plate C (Fig. 11) onto the support E and fasten
it in place with handle F.
You should adjust the height of the guide plate C in accordance
with the thickness and inclination of the piece to be edged A. To
do this, loosen handle F and screw G with the help of the service
key B and adjust the height and angle (max. 10º inclination)
of the guide plate C, so that the board is between 1.5 – 2 mm
above the base H of the machine. Do not pay attention to the
millimetre gauge, as this is only used to adjust panels to 90º.
It is very important that when carrying out this
type of work, you do not excessively fill the tank
(it is advisable to have the tank half full), since this
leads to the risk of the glue overflowing and causing
irreparable damage.
9. MACHINE WHEN HOT
ADJUSTMENTS TO THE MACHINE ONCE THE GLUE
HAS MELTED
9.1 Controlling the flow of glue
With the help of the flow control knob A (Fig. 15) you can
control the amount of glue to be applied to the edge. Proceed
as follows:
PEB200-PEB250 / Operating instructions - 25