Virutex PEB200 Gebrauchsanweisung Seite 31

C
A
B
(Figure 27)
(Figure 26)
B
(Figure 14)
D
E
F
C
A
Ensure that all the adjustments in points 8 and 9
below have been performed before continuing.
Next, place the guide plate A (Fig. 27) over the piece to be
edged B (Fig. 27) and move the pressure roller C (Fig. 27) close
to the piece but without touching it.
Hold the machine over the piece with your right hand and move
the edge with your left hand through the guides E (Fig. 27), to
the advance roller F (Fig. 27). The edge will be automatically
fed through to pressure roller C (Fig. 27).
When the edge appears between the panel and the pressure
roller C (Fig. 27), allow around 2 cm of edge to pass with res-
pect to the panel and press roller C against the edge and the
panel (Fig. 26). The edge will stick and the turning movement
of the pressure roller will move the machine forward (Fig. 26)
continuously and consistently, at a speed of between 2 and
6 metres/minute according to the difficulty of the piece, and
this can be selected using handle A (Fig. 14). The selected speed
will be shown by the corresponding yellow LED D (Fig. 14).
D
E
PEB200-PEB250 / Operating instructions - 31