Setting Up And Aligning The Appliance; Cleaning Before Use; Connecting The Appliance - hanseatic HBC115FRBH Gebrauchsanleitung

Page EN-18 Start-up
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure sufficient air circulation, do not
place the appliance directly against the
wall. Leave a gap of at least 10 cm to the
back wall and 5 cm to the sides and the
top.
3. Check the position with a spirit level.
4. Level out any unevenness on the ground
using the two front screw feet (3).
– Close the glass door (2).
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the glass
door.

Cleaning before use

To remove the odour that comes with all new
appliances, clean the appliance before us-
ing it (see "Care and maintenance" on page
EN-14).

Connecting the appliance

WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Do not operate or continue to oper-
■
ate the appliance if it
shows visible signs of damage, e.g.
–
the power cord is defective,
starts smoking or there is a smell of
–
burning,
makes unfamiliar noises.
–
In such cases, remove the mains plug
from the socket and contact our ser-
vice department (see page EN-22).
Connect the appliance only to a prop-
■
erly installed and earthed electric
socket.
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.
Do not kink or pinch the mains cord
■
or lay it over sharp edges.
All other important operating infor-
mation can be found starting on
page EN-11.