About Climate Categories; Setting Up And Aligning The Appliance - hanseatic HGS14355ENFW Gebrauchsanleitung

"Climate categories" table
Zone description
Extended temperate zone
Temperate zone
Subtropical zone
Tropical zone

About climate categories

• Always ensure the prescribed ambient
temperature is maintained (see "Intended
use" on page EN-4).
Climate category means that the appliance is
intended for operation at the specified ambi-
ent temperature (see table "climate catego-
ries"). If the room temperature drops signif-
icantly below this, the unit will not switch on
as often. This indicates that an unwelcome
increase in temperature may occur.
Setting up and aligning the
appliance
NOTICE
Risk of damage!
Insuffi cient air circulation may lead to
overheating and cause damage to the
appliance.
The entire space above the appliance
■
must remain clear.
The appliance should not stand di-
■
rectly against the wall (leave a mini-
mum clearance of 5 cm).
1. Place the appliance on as flat and as firm
a base as possible.
Code Definition
This refrigerator is designed for use at ambient tempera-
SN
tures of +10 °C to +32 °C.
This refrigerator is designed for use at ambient tempera-
N
tures of +16 °C to +32 °C.
This refrigerator is designed for use at ambient tempera-
ST
tures of +16 °C to +38 °C.
This refrigerator is designed for use at ambient tempera-
T
tures of +16 °C to +43 °C.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using the four screw feet (4) and (13).
• Close the door.
• Tilt the appliance backwards slight-
• Stand the appliance back up again and
• Repeat the process until the appliance
Start-up
(4)
ly and screw in/unscrew the screw
feet (4) or (13).
check the alignment with a spirit level.
is standing up vertically. The appliance
should not move when opening the
door.
Page EN-23
(13)