Setting Up And Aligning The Appliance - hanseatic HKS18560DEI Gebrauchsanleitung

About climate categories
• Always ensure the prescribed ambient temperature is maintained (see "Intended use" on
page EN-4).
Climate category means that the appliance is intended for operation at the specified ambient
temperature.
Zone description
Extended temperate zone
Temperate zone
Subtropical zone
Tropical zone
If the room temperature drops significantly below this, the unit will not switch on as often. This
indicates that an unwelcome increase in temperature may occur.
– If you would like to reduce these distances,
you can fit an insulation plate between the
appliances.
– If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid mate-
rial.
Setting up and aligning the
appliance
NOTICE
Risk of damage!
Insuffi cient air circulation may lead to
overheating and cause damage to the
appliance.
The entire space above the appliance
■
must remain clear.
The appliance should not stand di-
■
rectly against the wall (leave a mini-
mum clearance of 5 cm).
Code Definition
SN This refrigerator is designed for use at ambient temper-
atures of +10 °C to +32 °C.
N This refrigerator is designed for use at ambient temper-
atures of +16 °C to +32 °C.
ST This refrigerator is designed for use at ambient temper-
atures of +16 °C to +38 °C.
T This refrigerator is designed for use at ambient temper-
atures of +16 °C to +43 °C.
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using the two front screw feet (7).
– Close the door.
– Tilt the appliance backwards slightly and
– Stand the appliance back up again and
Start-up
screw in/unscrew the screw feet (7).
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the door.
Page EN-23
(7)