Setting Up And Aligning The Appliance; Cleaning Before Use; Connecting The Appliance - hanseatic HFD18983EI Gebrauchsanleitung

About climate categories
• Always ensure the prescribed ambient temperature is maintained (see "Intended use" on
page EN-4).
Climate category means that the appliance is intended for operation at the specified ambient
temperature.
Zone description
Extended temperate zone
Temperate zone
Subtropical zone
Tropical zone
If the room temperature drops significantly below this, the unit will not switch on as often. This
indicates that an unwelcome increase in temperature may occur.
Setting up and aligning the
appliance
• Place the appliance on as flat and as firm
a base as possible.
• Check the position with a spirit level.
• Level out any unevenness on the ground
using the two front appliance feet.
– Close the doors to do this.
– Tilt the appliance slightly back and screw
the appliance feet (7) in or out.
Code Definition
SN This refrigerator is designed for use at ambient temper-
atures of +10 °C to +32 °C.
N This refrigerator is designed for use at ambient temper-
atures of +16 °C to +32 °C.
ST This refrigerator is designed for use at ambient temper-
atures of +16 °C to +38 °C.
T This refrigerator is designed for use at ambient temper-
atures of +16 °C to +43 °C.
– Stand the appliance back up again and
(7)

Cleaning before use

To remove the odour which is present in all
new appliances, wipe the interior with dilut-
ed vinegar prior to first use. Then wipe it out
with clean water and dry all of the parts off
afterwards.

Connecting the appliance

• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
Start-up
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
doors.
You will find all important information
about operation from page EN-13.
Page EN-27