Troubleshooting Table - hanseatic HBC115FRBH Gebrauchsanleitung

Page EN-20

Troubleshooting table

Troubleshooting table
Malfunctions can occur in all electrical appliances. This does not necessarily mean there is a
defect in the appliance. For this reason, please check the tables to see if you can correct the
malfunction.
WARNING
Risk of electric shock in case of improper repair!
Never try to repair a defective or suspected defective appliance yourself. You can put
your own and future users' lives in danger. Only authorised specialists are allowed to
carry out this repair work.
Problem Possible cause
Compressor off, No electricity to socket.
interior lighting
cannot be
switched on.
Mains plug is loose.
Compressor off, Desired temperature has
interior lighting can been reached.
be switched on.
Appliance cools The temperature controller is
too quickly. set at too high a level.
The appliance The temperature setting is
does not cool set too low.
sufficiently.
Door not tightly closed or
door seal is not completely
tight.
The appliance is near a heat
source.
Appliance is standing in
direct sunlight.
Minimum distances not
maintained (too short).
Too many beverages being
stored.
Ambient temperature too low
or too high.
Compressor seems
defective.
Solutions, tips, explanations
Check the socket with another appliance.
Check the fuse. Check if there has been a
mains failure.
Check the tightness of the mains plug.
Further cooling not required. When the
inside temperature rises, the compressor
automatically switches on.
Select a lower setting (see "Setting the
temperature" on page EN-11).
Select a higher setting (see "Setting the
temperature" on page EN-11).
See "Checking and cleaning the door
seals" on page EN-14.
Place insulation plate between the
appliances or change location.
Change its location.
Ensure that minimum distances to walls
and other devices are upheld (see
"Choosing a suitable location" on page
EN-16).
Do not exceed the maximum total volume;
see type plate.
Adjust ambient temperature (see "Intended
use" on page EN-4).
Set the temperature controller to "7".
If the compressor does not switch on
within an hour, please contact our service
department (see page EN-22).