Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Before getting started
– Read the "Safety" chapter from page EN-4.
– Set up and connect the appliance as
described in chapter "Start-up" from
page EN-16.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the refrigerating appliance has been
transported horizontally, lubricant from
the compressor may get into the cool-
ing circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting.
(6)
Switching on
• Insert the mains plug into an easily acces-
sible socket (220–240 V~ / 50 Hz).
• Turn the temperature controller (6) to a
value higher than "0".
• The appliance is then switched on. The
compressor starts to work, the refrigerant
flows through the pipes and a quiet hum-
ming sound can be heard.
Operation
Switching off
1. Turn the temperature controller (6) to "0".
The compressor is switched off. The ap-
pliance will no longer be cooling, but will
still have electricity.
2. Disconnect the mains plug from the socket.
3. Empty the appliance and clean it (see
"Care and maintenance" on page EN-14).
4. Leave the glass door slightly ajar to pre-
vent mould from forming.
After switching off , wait at least 5 min-
utes before switching the appliance
back on. The compressor requires this
amount of time to re-start.
Setting the temperature
WARNING
Health hazard!
The appliance may not operate proper-
ly if the ambient temperature exceeds
or falls below the specifi ed temperature
range for a prolonged period. This can
then lead to an increase in temperature
inside the appliance.
Always ensure the prescribed ambi-
■
ent temperature is maintained (see
"Intended use" on page EN-4).
The ideal refrigerator temperature is +6 °C.
A temperature setting that is too high or too
low can reduce the shelf life of your food. This
leads to greater food waste.
• The appliance's cooling performance can
be continuously adjusted from "1" to "7"
using the temperature controller (6).
• Set the temperature to "7" for the maxi-
mum chilling capacity and therefore the
lowest temperature possible.
Set the temperature to "1" for the mini-
mum chilling capacity.
"0" is used to switch off the cooling.
• First select a medium setting.
Page EN-11
Werbung
Kapitel
Inhaltsverzeichnis
