Mounting The Front Panel; Adjusting The Door's Accessibility . En - hanseatic HGVI6082E137713IS Gebrauchsanleitung

11. Screw the dishwasher to the kitchen
unit.
– If you have granite worktops, remove
the internal side cover caps (e) and
screw the dishwasher to the adjacent
kitchen cupboards.
Re-cover the screws (k) with the cover
caps.
– For all other worktops, screw the
mounting bracket (f) firmly to the work
surface.

Mounting the front panel

You can mount a stainless steel front panel
on the appliance door, or another front panel
design which matches your kitchen. The front
panel must not exceed a weight of 7 kg.
1. Lay the enclosed drilling template on the
back of the front panel in such a way that
the drilling template and the front panel
are flush at the top.
2. Transfer the drill holes from the drill tem-
plate to the front panel.
3. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
(h) (g) (l)
4. Affix both installation hooks (h) with four
screws (l) each onto the front panel.
5. Affix both mounting pegs (g) using the
screws (j) onto the front panel.
Set-up, connection and initial start-up
6. Hang the front panel on the appliance
door, hold it in place and open the door
carefully.
(i)
7. Remove the 4 screws from the inside of
(j)
The front panel is then mounted.
(g)
Adjusting the door's
(h)
accessibility
You can adjust how easy or difficult it is to
open the appliance door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (i).
Page EN-31
(i)