Setting a Countdown Timer
You can set a countdown time for maximum 99 minutes and 59 seconds
delay.
-
Turn the housing so that the countdown timer is displayed (see figure
[8]). By default the display shows "00:00".
-
Press the SET button (3) once. The minute indicator will start blinking.
-
Press the ADJ button (2) multiple times to set the countdown minutes.
You can also keep the ADJ button (2) pressed down to accelerate the
digit adjustment.
-
Press the SET button (3) again. The second indicator will start blinking.
-
Press the ADJ button (2) multiple times to set the countdown seconds.
-
Press the SET button (3) again. You have finished setting the
countdown timer and the timer becomes enabled automatically.
After the set delay has expired, the device will emit an acoustic alarm
signal. Press any button to mute the sound. The countdown time will show
"00:00" and is therefore disabled.
Turning the housing when the alarm sounds will also mute the acoustic
signal. If you turn the housing back to the countdown timer display, the
previously set countdown time will show and the countdown starts
again from the beginning.
Displaying the Temperature
Turn the housing so that the temperature is displayed (see figure [9]).
You can choose between the units of measure degrees Centigrade and
Fahrenheit. Press the ADJ button (2) to toggle between the different units
English - 11