The reception of the DCF radio time signal by the alarm clock can
also be started manually.
Note: If the alarm clock was not able to receive the DCF radio
time signal because of data errors, e.g. due your location to being
at too great a distance from the transmitter or for other reasons,
you can set the time manually.
79133 ES.indd 47
Press and keep pressed the REC button
The alarm now starts to receive a signal again.
Setting the time manually
Press the M.SET button
clock switches into manual mode.
Press and keep pressed the M.SET button
hands reach the correct position for you to set the time. Release
the M.SET button
4
position.
Briefly pressing the M.SET button
in one minute steps to enable you to set the current time manually.
for at least 3 seconds. The alarm
4
when the hands have reached the desired
moves the hands forward
4
Operation
for a short while.
5
again until the
4
GB/MT
47
9/20/2012 5:06:51 PM