Description Of The Equipment; Applications; Identification Of Parts; Technical Characteristics - Rothenberger SOCKET WELDER P63-S4 Electronic Gebrauchsanweisung

GB
INSTRUCTION MANUAL

DESCRIPTION OF THE EQUIPMENT

APPLICATIONS

The SOCKET WELDER P63-S4 / P63-S5 has been designed to weld tubes and accessories made of PE, PP,
PB and PVDF, both in the workshop and on worksites.

IDENTIFICATION OF PARTS

Fig. 1 General view
The main parts that constitute the SOCKET WELDER P63-S4 / P63-S5 are shown in Fig. 1:
1. Heating plate
2. Cooling plate
3. Power LED (red)
4. Regulator knob
5. Temperature-control LED (green)
6. Body
7. Cable and plug, with earth connection
8. Legs
9. G-clamp
10. Adapters
Downloaded from www.Manualslib.com
16
manuals search engine
INSTRUCTION MANUAL

TECHNICAL CHARACTERISTICS

Voltage: 220-230 V AC / 110-115 V AC
Power/ Current:
Nominal power = 800 W
Frequency: 50/60 Hz
Working range: 20-63 mm
Temperature range: max.. 330 C
Dimensions: 475 x 359 x 110 mm
Weights:
• SOCKET WELDER P63-S4 / P63-S5
Thermostatic = 1.7 Kg
• SOCKET WELDER P63-S4 / P63-S5
Electronic = 1.6 Kg
• G-clamp = 0.4 Kg.

PREPARATION FOR USE

This equipment leaves the factory completely finished
and ready to use; it needs no adjustment or
preparation for use.

OPERATING INSTRUCTIONS

Welding with this unit consists of three phases:
• preparing the tube
• preparing the socket welding device
• the welding process.

A) PREPARING THE TUBE

• Cut the tube straight
across using a
suitable tool (pipe
cutter or cropper)
NOTE
17
GB
• Clean the surface to
be welded and the
adapters with
cellulose tissue
dampened with
isopropanol
• Mark the length of
the weld on the tube
The surfaces to be welded must be cleaned
immediately before welding.
Protect the surfaces from weather conditions.
B) PREPARING THE SOCKET WELDING
DEVICE
1) Mount the socket welding device
Mounting using the G-clamp
The socket welding device is supplied with a G-clamp
that can be used to attach it firmly to a workbench.
• Introduce the top section of the G-clamp into
the slot in the bottom of the unit