Introduction; Safety Notes; Improper Use Of The Welding And Power Supply Cables; Securing The Fitting And The Joint - Rothenberger ROWELD ROFUSE Sani 160 Bedienungsanleitung

1

Introduction

Dear Customer,
Thank you very much for purchasing our product. We are confident that it will meet your expec-
tations. The ROWELD ROFUSE Sani 160 & 315 Electrofusion Welding Unit is designed exclu-
sively for jointing PE discharge lines assembled with electrofusion fittings.
The product was manufactured and checked according to state-of-the-art technology and widely
recognized safety regulations and is equipped with the appropriate safety features. Before ship-
ment, it was checked for operation reliability and safety.
In the event of errors of handling or misuse, however, the following may be exposed to hazards
• the operator's health,
• the product and other hardware of the operator,
• the efficient work of the product.
All persons involved in the installation, operation, maintenance, and service of the product have
to
• be properly qualified,
• operate the product only when observed,
• read carefully and conform to the User's Manual before working with the product.
Thank you.
2

Safety notes

This device is not intended for use by children and persons with
physical, sensory or mental limitations or a lack of experience or
knowledge. This device can be used by children aged 8 and
above and by persons who have physical, sensory or mental
limitations or a lack of experience or knowledge if a person re-
sponsible for their safety supervises them or has instructed
them in the safe operation of the device and they understand
the associated dangers. Otherwise, there is a danger of operat-
ing errors and injuries.
Supervise children during use, cleaning and maintenance. This
will ensure that children do not play with the device.
The equipment must only be operated by qualified specialized
staff!
2.1

Improper Use of the Welding and Power Supply Cables

Do not carry the product by one of its cables and do not pull the power cord to unplug the unit
from the socket. Protect the cables against heat, oil, and cutting edges.
2.2

Securing the Fitting and the Joint

Use appropriate clamps to secure the fitting and the joint before welding. The welding unit is
intnded exclusively for indoor installation applications. Use for buried pipeline construction appli-
cations is prohibited.
2.3

Cleaning the Welding Unit

The product must not be sprayed with or immersed in water.
10 ENGLISH