Troubleshooting - Silvercrest SPB 10000 A1 Bedienungsanleitung

NOTE
►
♦ During the charging process, the current charge level of the Power Bank is
shown via the charge level LEDs
the charge level").
♦ To stop charging, disconnect the charging cable from the mobile device and
the Power Bank. The charging status LEDs

Troubleshooting

The Power Bank does not charge
♦ Connection may be faulty. Check the connection.
♦ Sometimes, a USB 2.0 connection will not be sufficient for charging the
Power Bank. If this is the case, use a USB 3.0 connection or a separate
mains adapter.
♦ Some computers deactivate the power supply to the USB ports when they
are switched off. Check that the computer is switched on.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button
The charging process stops after about 15 seconds
♦ The charging current of the connected device is less than 120 mA.
This device cannot be charged with the Power Bank.
The Power Bank does not react when several devices are connected
even though the battery is charged
♦ The power consumption of the connected devices is too high. This has trig-
gered the internal overcurrent protection. Reduce the number of connected
devices and press the ON/OFF button
NOTE
►
│ GB │ IE
■ 8
If the device to be charged has a Micro-USB, you can also use the
Power Bank's Micro-USB charging cable
If you cannot solve the problem with the above-mentioned solutions,
please contact the Service Hotline (see chapter entitled Service).
.
(see table in chapter entitled "Checking
go off after about 15 seconds.
to start the charging process.
.
SPB 10000 A1