Disposal Of Packaging Materials; Charging The Power Bank; Led Display; Charge Level - Silvercrest SPB 10000 A1 Bedienungsanleitung

Disposal of packaging materials

The packaging protects the device from damage during transport. The
packaging materials have been selected for their environmental friendli-
ness and ease of disposal, and are therefore recyclable.
Returning the packaging into the material cycle conserves raw materials and
reduces the amount of waste generated. Dispose of packaging materials
that are no longer needed in accordance with applicable local regulations.

Charging the Power Bank

Before using the Power Bank, the integrated battery must be fully charged.
The required charging time for the Power Bank is dependent of the charging
source and its output (max. 5 V/1 A).
CAUTION!
►
►
►
Option A
♦ Connect the USB plug
power supply (not supplied). The current charge level is shown during
charging by means of the charge level LEDs

LED display

One LED is flashing
One LED is on, the second LED is flashing
Two LEDs are on, the third LED is flashing
Three LEDs are on, the fourth LED is flashing
All LEDs are on
│ GB │ IE
■ 6
Only use mains adapters with an output voltage of 5 V and an output
current of at least 1 A or a USB 3.0 port on your computer to charge
the Power Bank. You can recognise the USB 3.0 port due to the blue
marking.
If you use another USB port, make sure that you leave at least one
additional connection free.
Not all USB 2.0 ports deliver sufficient power to charge the Power Bank.
If this is the case, use an external power supply or a USB 3.0 port.
of the Power Bank to a switched-on PC or a USB
:

Charge level

< 25%
25–49%
50–74%
75–99%
100%
SPB 10000 A1