Troubleshooting - Yard Force SA600H Originalanleitung

Trouble Shooting For Charging Station
LED
1 Blue light on
2 Blue flash, Red off Charging station internal wire break, main Boundary is OK
3 Red flash, Blue off
4 Red and Blue flash
Main Customer Trouble Shooting
No. Message
1 NONE
2 NONE

TROUBLESHOOTING

Normal
Boundary cut off or poor connect, charging station internal wire
is OK if the mower is charging ,means normal
Boundary and charging station internal wire both short circuit or
cut off
type of
Symptom
message
blank screen
Your Mower
cannot enter the
charging station
Description
1. Confirm the Isolated switch is
"ON"
2. When you first use the mower the
battery may not be fully charged
please switch off and then carry
the mower to charging station,
once positioned in charging
station turn on switch again.
3. For normal working, press start
key on control panel, then start
the mower. Of mower does not
work, enter Error menu and
check fault code, once the fault
has been detected it can be
corrected and mower can then
cut.
4. In normal working if you press
any key on control panel, but
the screen is still blank carry the
mower to charge station. After 5
minutes, you can follow step 3.
5. High environmental temperature
can lead the machine
components to be protected,
when temperature is reduced, the
mower can working.
1. Check if boundary wire under and
in front of the charger is straight
line.
2. Check that the charging station
is positioned according to clause
4.3.of manual.
52
Action