Yard Force SA600H Originalanleitung Seite 33

Press the Mower Power isolated switch to "ON". (Press again for OFF)
See later for further explanation.
Now press the large STOP button on top of Mower then the keypad top cover will open.
Press the key Marked HOME (situated to right of display) and then manually press the top
cover to closed position. Once closed the Mower should start and will automatically return
to the Charging station by locating a Boundary wire and following it. The mower should
follow the wire in an anti-clockwise direction and when gets close to the Charging station
and dock into charging position. The mower will start to fully charge. If robot misses to
dock, you might have to adjust the charging station sideways until robot docks without any
problem.
After successfully dock into the charging station, the symbol
the battery symbol will display step by step
which means that the robot mower is charging now.
INSTALLATION GUIDE
Power Isolation
switch status:
OFF (Released)
Set
31
Power Isolation
switch status:
ON (Pressed)
Home
Start
will flash. Meanwhile,
,