Yard Force SA600H Originalanleitung Seite 56

10
flash
11
flash
12
13 EF1
14 EF 2
TROUBLESHOOTING
The mower cannot
Warning receive the signal
message sent from the
boundary wire
Your mower is or
Warning has been outside
message of the boundary
wire.
Note
Still Mowing
message
Warning Means obstacle
message sensor is stuck
Warning Your mower has
message been tilted
1. Check if the charging station
indicator light is blue.
2. Check if charging station is
connected with power if indicator
light is not lit.
3. Fi the indicator light is red, please
check if the boundary wire is
connected to charging station.
4. If it is your first use after power
off carry to nearby boundary.
5. Check your choice signal S1,
S2 in control panel if same as
charging station setting.
1. If the Mower is still inside the
boundary area when the display
shows flashing please check
if the boundary is connected
correctly.
2. If the mower is outside of
boundary put it back into the
inside area and restart.
3. If the mower runs outside of
boundary at a corner , please
adjust and enlarge the corner
angle to exceed 90°.
4. If the Mower runs outside of the
boundary at on place several
times please check if there is
a high power cable nearby or
underneath if it is the case please
avoid that area by changing the
position of the boundary wire if
possible.
Proper functioning
Inspect is there anything stick
into the clearance between main
housing and the driving car.
Check if the slope is too slippery
to climb if so the boundary wire
must be corrected to mark a
usable area. Normally your mower
can climb realistic slopes with no
problem.
54