Troubleshooting - Yard Force SC600ECO Originalanleitung

TROUBLESHOOTING

Trouble Shooting For Charging Station
LED
1 Blue light on Normal
2 Blue flash, Red off Charging station internal wire break, main Boundary is OK
Boundary cut off or poor connect, charging station internal wire
3 Red flash, Blue off
is OK, or the mower is charging ,it's OK
Boundary and charging station internal wire both short circuit or
4 Red and Blue flash
cut off
No. Message Symptom
1.
Your mower
1 NONE cannot enter the 2.
charging station
1.
The mower turns
around in circles
when running or 2.
2 NONE
back to charging 3.
station along the
boundary wire.
4.
1.
2.
The mower is very
3 NONE
noisy
3.
4.
Press start but
the mower is 1.
4 NONE
home instead of 2.
cutting
1.
Your mower has
been lifted during
5
use for some
LED flash
reason
2.
Description
Action
Check if boundary wire under and in front of
the charger is straight line.
Check that the charging station is positioned
according to clause 4.3.of manual.
Check if there is high power cable close to
Boundary wire or underneath it, if there is then
avoid the area by changing the position of the
boundary wire.
Check if one of the front wheel stuck.
Check if your neighbor have the same mower,
and you can set the S2 signal different from
neighbor's S1 signal.
Maybe some problem with the driving motor,
please call after sales service.
Check if the blade screw is loose, and you can
tighten the screw.
Check if the cutting blade is damaged, and
you can change the new blade.
Grass too high, increase the cutting height.
Cutting motor failure, please call after sales
service
Check if the mower is on working time.
Check if the battery is very low
Check if the lifting is caused by too high grass
(taller than 60 mm). If souse a normal lawn
mower to cut the grass before you start your
mower again.
Check the mower is free from obstructions.
44
TROUBLESHOOTING
1.
2.
The mower cannot
3.
receive the signal
6
sent from the
LED flash
boundary wire.
4.
1.
Battery voltage is
7 too low to perform 2.
LED flash
normal mowing.
In the process of
8
charging
LED flash
Check if the charging station indicator light is
green.
Check if charging station is connected with
power if indicator light is not lit.
If the indicator light is red, please check if
the boundary wire is connected to charging
station.
If it is your first use after power off carry to
nearby boundary. Check your choice signal
S1, S2 in control panel if same as charging
station setting.
Normally if voltage is low, the mower should
automatically return to the charging station.
If not, please carry your mower manually to
charging station when it has stopped on the
lawn.
Proper function.
45