Maintenance; Troubleshooting; Technical Data - OHAUS PX Serie Handbuch

EN-4
DISPLAY
Net (NET)
Stability (*)
Negative (-)
Centre of Zero (>0<)
Preset tare (PT)
Instructional Messages
3.2 Principal Functions
Zeroing: Press
Taring: With no load on the pan, press
on the pan and press Tare. Add material to the container and its net weight is displayed.
After the container and the objects are removed, the tare value will be displayed as a
negative number. Press Tare to clear.
Weighing: First press Zero to set the display to zero. Place an object on the pan. The display
indicates the gross weight.
Dot-matrix The relevant data in the specific application mode are shown in the dot-matrix display
Display: area.

4. MAINTENANCE

4.1 Cleaning
WARNING: Disconnect the balance from the power supply before cleaning.
Make sure that no liquid enters the interior of the balance.
Clean the balance at regular intervals.
Housing surfaces may be cleaned with a lint-free cloth slightly dampened with water or a mild
cleaning agent.
Glass surfaces may be cleaned with a commercial glass cleaner.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.

4.2 Troubleshooting

If the troubleshooting section does not resolve your problem, contact an Authorized Ohaus Service
Agent. Please visit our website www.ohaus.com to locate the Ohaus office nearest you.

5. TECHNICAL DATA

The technical data is valid under the following conditions:
Indoor use only
Altitude: Up to 2000 m
Specified Temperature range: 10°C to 30°C
Humidity: maximum relative humidity 80% for temperatures up to 30°C, decreasing linearly to 50%
relative humidity at 40°C
Mains supply voltage fluctuations: up to ±10% of the nominal voltage
Installation category II
Pollution degree: 2
Zero to zero the balance.
Zero to set the display to zero. Place an empty container
Result Field:
Information varies
by application
Unit