Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.0. New TermaTech wood-burning stove
Congratulations on your wood-burning stove.
We thank you for choosing a TermaTech wood-burning stove and hope that you will have many
cosy and warm moments in the future.
Your new TT70 stove from Termatech is a normal convection stove. The stove has been tested ac-
cording to the best enviromental requirements.
Before using the stove you should read the user and mounting manual so that you are familiar
with the legal requirements as well as the instructions regarding maintenance. By this it is ensu-
red that the product functions as intended and you get the most out of your investment for many
years to come.
2.0. Installation instruction
INSTALLATION INSTRUCTIONS IN SMOKE CONTROL AREAS
Installation in a smoke control area requires the additional assembling / installation of the "Dam-
per control unit" which must be installed by the installer. See drawing and picture on page 44.
The stove is intended for "intermittent combustion" it is not meant to burn over night. By fol-
lowing the instruction below in "lighting instruction" the best and most environmentally friendly
combustion is achieved.
The wood-burning stove is delivered ready for Installation (ensure the correct outlet socket is
used, sealed and secured) and must be connected to the chimney with a smoke (flue) pipe. The
connection between stove and chimney must, as far as possible, be mounted in one straight piece
(with as few bends as possible) any horizontal section must be kept to a maximum of 150mm,
but preferably rising vertically from the stove to the chimney (all Joints must be tight) with an ac-
cess for sweeping the smoke (flue) pipe.
EN15287-1 allows an 'Acceptable Alternative method' e.g. 450mm horizontal section of connec-
ting smoke (flue) pipe into a chimney system, please ask your supplier for details.
2.1. Placing of the stove
Distance to walls and flammable material. See section 12.
2.2. Floor requirements
The floor underneath must be able to support the combined weight of the stove and possibly the
chimney.
The stove must be mounted on a non flammable surface. The surface should at least cover
150mm to each side of the stove and 300mm in front of the stove opening.
2.3. If the stove is to be mounted with a rear outlet, then do the following
Remove (possibly break off) the cover plate at the rear of the stove, all the way to the burning
chamber which provides free passage to the chimney. Subsequently remove the cover plate which
is screwed on the burning chamber. The universal nozzle which is mounted on the top of the stove
is removed and mounted on the rear of the stove. The cover plate which was mounted at the rear
of the stove is now at the top of the stove. The chimney is now ready to be installed.
2.4. Requirements for the chimney
The chimney must be of sufficient height so that the draught conditions are good and so that
the smoke does not bother any neighbours. Good draught in the chimney is crucial for the stove
to work as intended and burn as environmentally friendly as possible. All joints and connections
must be tight and the chimney must be able to provide a draft of at least 1,2mm water gauge
(12Pa)
It is possible to connect the wood-burning stove to chimneys that are also used for other purpo-
ses. However, the specified conditions must be assessed by the fitter and/or chimney sweeper.
2.5. Approval of the installed stove
When your new wood-burning stove has been installed please notify your local chimney sweeper.
The chimney sweeper must check the installation before use as well as regular future cleaning.
29
38
38
38
39
40
44
Werbung
Kapitel
Inhaltsverzeichnis
