Maintenance; Adjusting The Water Temperature - Geberit Piave Betriebsanleitung

Maintenance

Adjusting the water temperature

The water temperature can only be
adjusted on Geberit washbasin taps with a
mixer or a thermostatic mixer.
If a mixer is used, a specific mixing ratio
between hot water and cold water is set. If
a thermostatic mixer is used, a constant
water temperature is set.
1
Detach the cover plate. → See illustration
sequence 1 , page 237.
2
Adjust the water temperature on the mixer or
thermostatic mixer. → See illustration
sequence 2 , page 238.
3
Test the water temperature.
4
Mount the cover plate. → See illustration
sequence 6 , page 243.
Activating cleaning mode
In cleaning mode, the flush actuation is suppressed
for 2 minutes. The washbasin tap and washbasin
can be cleaned during this time.
1
Cover approx. 1 cm of the IR window (at the
bottom on a deck-mounted tap, on the left
on a wall-mounted tap) for approx.
2 seconds until the green LED lights up 1x.
✓ The washbasin tap is in the setting mode.
45035998285466763-1 © 03-2020
967.455.00.0(02)
2
Cover approx. 1 cm of the IR window (at the
bottom on a deck-mounted tap, on the left
on a wall-mounted tap) for approx.
0.5 seconds (2x).
✓ The green LED lights up 1x.
✓ The red LED flashes for 2 minutes. The
cleaning function is activated throughout
these 2 minutes.
Options:
• the function can be terminated prema-
turely by covering the IR sensor for
approx. 2 seconds.
• you can also activate the function with
Geberit Clean Handy.
• the function can be blocked by a skilled
person.
Activating continuous flush
When the continuous flush is activated, the water
flows continuously for 10 minutes. The washbasin
can be cleaned with flowing water, for example,
during this time.
1
Cover approx. 1 cm of the IR window (at the
bottom on a deck-mounted tap, on the left
on a wall-mounted tap) for approx.
2 seconds until the green LED lights up 1x.
✓ The washbasin tap is in the setting mode.
EN
15