Maintenance - Geberit 501-1 Betriebsanleitung

Maintenance

Activating cleaning mode
In cleaning mode, the flush actuation is
suppressed for 30 minutes. During this
time, you can clean the urinal.
1
Using your bare hands, hold a
metallic, non-insulated object in the
residual water in the urinal ceramic
appliance for approximately
15 seconds.
✓ Two flushes with a flush time of
5 seconds, spaced 4 seconds
apart, are actuated.
2
Clean the urinal.
✓ A flush with a flush time of
7.5 seconds is actuated after
30 minutes. Cleaning mode is
deactivated.
Caring for and cleaning
smooth surfaces
All smooth surfaces can be cleaned hygien-
ically with water and a mild, liquid cleaning
agent that is kind to the skin.
ATTENTION
Surface damage caused by
aggressive and scouring
cleaning agents
▶ Never use cleaning agents
that contain chlorine or which
are acidic, abrasive or
corrosive.
18014402741989259-1 © 07-2019
968.645.00.0(01)
Cleaning the urinal trap
It is essential to clean the urinal trap
regularly in order to keep the urinal flush
control functioning correctly. Hard water
and urine will cause urine scale deposits to
build up. These deposits may impair the
function of the sensors in the urinal trap and
clog the urinal trap.
Cleaning recommendations:
• Use standard WC cleaning agents for
deposits from hard water.
• Also remove any deposits in the trap
bend and in the adapter leading to the
discharge pipe.
• If the deposits are heavy, replace the
urinal trap.
Replacing the urinal trap
Prerequisite
– Urinal ceramic appliance has been
demounted.
– Refer to illustration sequence
page 60 while carrying out the
instructions.
1
Disconnect the cable for the control
unit.
2
Demount and dispose of the urinal
trap.
3
Mark the insertion depth on the new
urinal trap.
4
Measure, cut and deburr the urinal
trap.
5
Lubricate the sleeve and mount the
urinal trap.
6
Connect the cable for the control
unit.
EN
1 ,
23