Fantic INTEGRA 150 TRAIL Bedienungs- Und Wartungsanleitung Seite 98

Troubleshooting
08
1. TROUBLESHOOTING
If you encounter problems while riding your bicycle, first check whether the fault is described in the following
tables.
This table is designed to help you identify the correct solution without taking your bicycle to the authorized
vendor.
If the problem is not described in the table, or the proposed solution does not correct the fault, consult the
authorized vendor before using your bicycle again.
Problem
It is not possible to activate the
display or the power-assisted
pedalling system.
The display does not provide any
data, even though the bicycle is in
motion.
The bicycle lights (if fitted) do not
switch on.
The display indicates an error
code.
EN_36
Possible cause
The battery pack has malfunction,
despite being fully charged.
Battery pack overheated.
Battery pack not installed correct-
ly.
Battery pack discharged.
Electrical contacts on battery
pack and/or connector damaged.
Display not mounted correctly on
its support.
Display and/or support contacts
damaged.
Connector not inserted correctly
into the battery pack.
The contact on the rear wheel
spokes has not been mounted
correctly or is positioned too far
away from the sensor.
Light power supply cables on
connected correctly.
A system error is present.
Possible solution
Press the white push-button on
the battery pack to check whether
it is switched on. The battery pack
charge level indicator LEDs should
switch on. If they do not, the bat-
tery pack may be defective.
Wait until the battery pack has
cooled down.
Remove the battery pack and
attempt to reinsert it into its cou-
pling. Make sure that it is posi-
tioned correctly.
Recharge the battery pack using
the dedicated battery charger.
Make sure that all the contacts are
clean. If necessary, clean them us-
ing a soft, dry cloth.
Remove the display from the sup-
port and reposition it. Make sure
that it has been inserted correctly.
Make sure that all the contacts are
clean. If necessary, clean them us-
ing a soft, dry cloth.
Insert the connector correctly
into the battery pack contact.
Check the position of the con-
tact on the rear wheel spokes; in
particular, the distance from the
speed sensor must be between 5
mm and 17 mm.
Check the cables and the electri-
cal plugs and connect them cor-
rectly.
Consult the following table.
Ed. 1 - 07/2019