Fantic INTEGRA 150 TRAIL Bedienungs- Und Wartungsanleitung Seite 78

Assembly and Adjustments
04
- Align the tip of the saddle so that it is pointing
towards the from of the bicycle.
- Re-tighten the saddle support tube locking
collar (MAX tightening torque 8 Nm).
(fig. "28")
3.b - For "160" and "180" versions
• Seat tube adjustment
- Loosen the saddle locking screws (using a 6
mm Allen key) (fig. "23").
- Adjust the angle of the saddle as desired. (fig.
"30").
Do not raise the seat tube above
the "0" indication on the tube it-
self.
- Re-tighten the saddle support tube locking
collar (MAX tightening torque 8 Nm).
(fig. "28")
• Regulating height
- The seat height adjustment can be performed
while being seated on the seat itself.
- To adjust the seat height press the lever (1),
then push the seat downwards or reduce pres-
sure to make it raise (fig. "31").
- Once you've reached the desired height, re-
lease the lever (1) (fig. "29").
EN_16
3.c - Regulating the saddle position
and angle
- Loosen the saddle locking screws (using a 6
mm Allen key) (fig. "32").
- Adjust the angle of the saddle as desired (fig.
"33").
- Tighten the screws respecting the correct
torque values (see paragraph "4" - Section "03")
(fig. "34").
4. ADJUSTING THE BRAKE LEVERS
- If you wish to adjust the position of the brake
levers:
The procedure described below is valid for
both brake levers.
· Loosen the lever locking screw (using a 5
mm Allen key) (fig. "35").
· Adjust the angle of the lever as desired (fig.
"36").
· Tighten the screws respecting the correct
torque values (see paragraph "4" - Section
"03") (fig. "37").
5. ADJUSTING THE GEAR
CHANGE LEVER
- If you wish to adjust the position of the gear
change lever:
· Loosen the lever locking screw (using a 5
mm Allen key) (fig. "38").
· Adjust the angle of the lever as desired (fig.
"39").
· Tighten the screws respecting the correct
torque values (see paragraph "4" - Section
"03") (fig. "40").
Ed. 1 - 07/2019