Mounting Of Protector - Makita EM4351UH Originalbetriebsanleitung

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector
combinations as indicated in the table must be used.
Be sure to use genuine MAKITA metal blades (including saw
blade and cutter blade) or nylon cutting head.
– The metal blade must be well polished, free of cracks or breakage.
If the metal blade hits against a stone during operation, stop the
engine and check the blade immediately.
– Polish or replace the metal blade every three hours of operation.
– If the nylon cutting head hits against a stone during operation, stop
the engine and check the nylon cutting head immediately.
CAUTION: The appropriate protector must always be installed, for
your own safety and in order to comply with accident
prevention regulations.
Operation of the equipment without the guard being in
place is not permitted.
The outside diameter of the cutter blade must be 300 mm
(12") or smaller. Never use any blades exceeding 300
mm (12") in outside diameter.
Use 200 mm saw-blade protector only when using 200
mm saw-blade.
Use 225 mm saw-blade protector only when using 225
mm saw-blade.
Do not apply other combination when using sawblade.
NOTE: The standard combination of cutting tool differs from county to
country.
18