Mounting Of Protector - Makita EBH252U Originalbetriebsanleitung

MOUNTING OF PROTECTOR

WARNING:
Always use the tool with the approved combination of the safety equipments. Otherwise contact with a cutting tool may cause serious
injury.
CAUTION:
Tighten the right and left bolts evenly so that the gap between the clamp and the protector is constant. Otherwise the protector may not function
as expected.
To meet the applicable safety provisions, only the tool / protector combinations as indicated in the table must be used.
Use of metal blade
Clamp washer, cup,
Metal blade Protector
and nut are necessary
Type A
Use of nylon cutting head
Nylon cutting head Protector
Type A Type B
For metal blade
Fix the protector type A (1) to the clamp (2) with two bolts M6 x 25 (3) with hex
3
wrench 5 (4).
4
1
2
11