Mounting Of Handle - Makita EM4351UH Originalbetriebsanleitung

MOUNTING OF HANDLE

CAUTION: Before doing any work on the equipment, always stop the engine and pull
the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the engine only after having assembled it completely.
For model EM4351UH, EM4350UH
Insert the shaft of the handle into the grip as shown.
Align the screw hole in the grip with the one in the shaft. Tighten the screw securely.
– Loosen knob (1).
– Place handle (4) between handle clamp (2) and handle holder (3).
– Adjust handle (4) to an angle that provides a comfortable working position and then
secure by firmly hand-tightening knob (1).
CAUTION: Do not forget to mount spring (5).
For model EM4350LH
– Fix the loop handle on the shaft with four screws.
– To keep a proper distance between the grips, place the spacer (1) between the
loop handle and the hanger (2).
17