Makita EM4351UH Originalbetriebsanleitung Seite 25

STARTING
Move at least 3 m away from the place of refueling. Place the unit on the ground taking care that the cutting tool does not come into contact with
the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to OPERATION.
3) Choke lever
Close the choke lever.
Choke opening:
- Full closing in cold or when the engine is
cold.
- Full or half opening if the engine is a bit
warm, such as restarting engine just after
stopping during warm-up operation.
4) Primer pump
Continue to push the primer pump until
fuel comes into the primer pump. (In
general, 7 to 10 pushes.)
If the primer pump is pushed
excessively, an excess of gasoline
returns to the fuel tank.
25