Joie i-Spin 360 R Bedienungsanleitung Seite 11

Securing Child
1. Press the webbing adjustment
button, while pulling out the
shoulder harnesses to the desired
(Pull from below the fixed
shoulder pads to lengthen) length.
25
2. Unlock the buckle of the
harnesses by pressing the red
button.
26
3. Fix the buckles on the both sides
of the seat shown as which
27
located on the both sides of seat
to make placing the child
facing mode more convenient.
4. Please make sure the infant Insert
has the wedge assembled before
using it for infant.
28
19
25
26
27
in rear
28
Detach the snaps on
the head support to
remove the head
portion of the infant
insert.
We recommend using the
full infant insert while the
baby is under 60cm and can
be used until they outgrow
the infant insert. The infant
insert increases side impact
protection.
5. Place the child into the enhanced child restraint and pass both arms
through the harnesses.
!
After the child is seated, recheck whether the shoulder harnesses
are at the proper height.
6. Engage the buckle. Please refer to
29
Remove the head support
portion of the infant insert
when the child's head no
longer fits comfortably.
Remove the body portion
of the infant insert when
the infant's shoulders no
longer fit comfortably.
Remove the infant insert
1
wedge by detaching the
snaps to allow more space
when the infant does not
fit comfortably. The
wedge can be used
separately without being
2
attached to the infant
insert to bolster the
infant's back for more
comfort.
29
20