Cleaning And Maintenance; Accessories - eta Rotelo Bedienungsanleitung

GB
INPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 1. To fit a new input filter in
the vacuum cleaner, proceed in reverse order.
VI. CLEANING AND MAINTENANCE
– For hygienic purposes we recommend that you empty the container and clean the
filter after each use.
– Maximum suction power can be achieved when the filter is clean and the dustbag is
empty.
– Every time you empty the dust container, we recommend that you also clean the
filter.
– When you are vacuuming very fine dust, the filter pores might get clogged. This
reduces the air flow and reduces the suction power. In such a case, the filter needs
to be cleaned even though the container is not full yet.
Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive
detergents!

Accessories

After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Floor nozzle with rotary brush
Remove any dirt (especially hair, animal hairs, etc.) stuck to the brush. To make cleaning
easier, the brush can be removed (Fig. 5).
Mopping adaptor
Allow excessive water (solution) to come out from the mopping adapter. Rinse adaptor
F in flowing water. Mopping textile F1 can be washed in washing machine (washing
temperature 60 °C). Washer dryer can also be used.
Dust container
Rinse the plastic parts (B, B2) and filter B1, B3 under running water. Allow all the parts to
dry out properly before next use.
– Do not clean the filter with any aggressive washing or cleaning detergents or hot
water.
– The filter is not dish-washer safe.
Notes
Caution
30 / 57