Restraining Your Child In The Axkid Bigkid Car Seat; Seat Adjustments - Axkid Bigkid 2 Bedienungsanleitung

Restraining your child in the Axkid Bigkid car seat

6. Place your child in the Axkid Bigkid, pull out the vehicle seat belt and slot it ́s shoulder strap through the red shoulder
belt guide (L) nearest the belt attachment.
7. Pull out the vehicle seat belt in front of your child to the vehicle seat buckle. Lock the vehicle seat belt into the buckle
ensuring it "CLICKS" into place.
8. Place the lap belt through the red side lap belt side guides (F)
9. Slot the lap belt into the lap belt middle guide (E). Although optional we strongly advise using the middle lap belt
guide. (NOTE: The lap belt middle guide (E) is only available on the Bigkid 2 Premium version)
IMPORTANT: Tighten the vehicle seat belt by pulling the diagonal seat belt section, check that all slack has been removed
from the vehicle seat belt.

Seat adjustments

10. To adjust the height of the Axkid Bigkid, squeeze the headrest adjustment handle (K) on the back of the headrest (A)
and move the headrest up or down to one of its positions until the correct height is achieved.
11. The correct height of the headrest is when there is 1 cm between the child' s shoulder and the lower edge of the
headrest (A). Once the right fit is found release the handle and check the headrest to ensure it is locked into position.
12. The recline of the Axkid Bigkid backrest can be adjusted to enable different sitting positions. Pull the Recline
adjustment handle (G) and pull the seat forward or backward relative to the base.
IMPORTANT: NEVER place your child in the Axkid Bigkid whilst it is not fitted in a car. The Axkid Bigkid should never be
used free-standing as it may tip backwards
IMPORTANT: The lap belt is worn low over the hips. Check that the lap belt passes through both red lap belt side guides
(F) and the lap belt middle guide (E). Check that the shoulder belt passes through the red shoulder belt guide (L) then
diagonally across the child' s chest and through the red lap belt side guide (F) nearest to the seat belt buckle. Finally, check
that all slack has been removed from the vehicle seat belt.
IMPORTANT: Make sure the seat belt buckle is not wedged or interfering with the lap belt side guides (F)
WARNING: An unoccupied Axkid Bigkid should be secured using a 3-point seat belt or the ISOFIX connectors if available.
IMPORTANT: DO NOT recline the child seat' s backrest beyond the allowable adjustable range. If you hear a loud "click"
whilst adjusting the backrest, then you have gone past the allowable range. Reclining the vehicle seat may adversely
affect the position of the vehicle seat belt across the child and may result in death or serious injury during a crash. Refer to
your vehicle owner' s manual for adjusting the vehicle seat back with child seats.
10
GB