Placing Your Child In The Child Car Seat; Using The Retractable Cup Holders; Removing And Refitting The Seat Covers - Axkid Bigkid Bedienungsanleitung

Placing your child in the child car seat

When correct installation of the child car seat is achieved, place your child in the child car seat
11
Pull out the vehicle seat belt and guide it in front of your child to the vehicle seat buckle
12
Tighten the vehicle seat belt by pulling the diagonal seat belt section

Using the retractable cup holders

The child car seat has two retractable cup holders (one per side). Simply pull out one or both cup
holders as required and push them back in when not needed.
IMPORTANT:
DO NOT use with hot liquids.
DO NOT step on, put excessive weight or use excessive force on the cup holders.

Removing and refitting the seat covers

Before starting: raise the headrest up (this will allow more room to work). Starting with the base cover;
remove the elastic loops (i, ii) from their hooks and remove the base cover. Headrest cover: remove
the elastic loops (iii, iv) from their hooks and remove the head cover. Side-wing covers: pull the cover
from the top of the wing and then down and off. Repeat on the other wing. To refit the seat covers:
reverse the above steps.
8