Placing Your Child In The Seat - Axkid Move Bedienungsanleitung

29
Now firmly pull the straps on both sides of the seat to make sure that your seat is fully secured.
If you have installed Move in the back seat you can now move the front seat to a comfortable position.
Note: The back of the child restraint may, but does not need to be in contact with the back of the front
seat.
Using the side impact protection pad
Although optional we STRONGLY advise using the side impact pad where possible to add extra
protection from side collisions.
Locate the side impact pad connector (K) on the child seat nearest to the side of the vehicle (i.e.
30
closest to the door).
IMPORTANT: Ensure the two triangular arrows (i) on the side impact pad (H) point in the same
direction as the triangular arrow on the side impact pad connector (K).
Place the upper of the two oval openings on the underside of the side impact pad over the side
impact pad connector. Push the side impact pad against the side of the car seat and slide the side
impact pad upwards onto the side impact pad connector. You will feel a slight click as the side impact
pad locks in place.
To remove: Push the side impact pad downwards and remove.

Placing your child in the seat

Before placing your child in the seat, ensure you have adjusted the headrest and harness to the correct height
for your child (see steps 2 to 14)
Press the harness adjuster button (E) and pull forward on the shoulder straps (not the shoulder pads)
31
to completely loosen the harness.
32
Press the red harness release button on the buckle and unfasten the harness.
Place your child in the car seat. Put your child' s arms in between the shoulder straps so that the
33
straps are hanging over the chest and stomach.
34
Pull the shoulder straps together and insert the harness tongues into the crotch buckle.
Pull the harness adjustment strap (F). It' s important that you always pull the harness straight
35
and central when you tighten the adjustment strap. Failure to pull the harness correctly may
cause the strap to jam in the mechanism.
8