Product Description; Installing The Car Seat In The Vehicle - Axkid Nextkid Bedienungsanleitung

• DO NOT attempt use any part of this child car seat with any other child car seat.
• DO NOT (except where described in this manual), attempt to disassemble or modify this child car seat or
change the way the vehicle's seat belts are used.
• DO NOT use the child car seat in the home, or any other non-certified location. It has only been designed to be
used in a car.
• Ensure that The child car seat is always secured to the vehicle car seat - even when not in use.
The child car seat must not be used without the textile cover.

Product Description

Product Group
100cm-135cm
Nextkid
135cm-150cm
Nextkid
1
Installation Type
3-point Bell/
Universal
ISOFIX+3-point Belt
Special
3-point Bell/
vehicle
ISOFIX+3-point Belt
8 8
Allowed and disallowed positions
The Axkid Nextkid can be used on any forward-facing passenger seat which has a 3-point seat belt,
approved to UN/ECE Regulation No. 16 or other equivalent standard. The Axkid Nextkid cannot be used
with a 2-point lap belt.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward-facing seat with 3-point safety belt
Seat with 2-point safety belt
Side-facing seats
Rear-facing seats
IMPORTANT: The child should be a minimum of 140 cm in height to sit in front of an active airbag unless there are other
recommendations from the car manufacturer. If you still wish to install Axkid Nextkid in such seating position the airbag
must be switched o according to the vehicle manufacturers instructions. it is important to always check if the vehicles
indicator light shows that the airbag is turned o .
IMPORTANT: Never use on rearward or side facing vehicle seats.

Installing the car seat in the vehicle

1. Place the child car seat in a suitable forward-facing position equipped ISOFIX connection points. If the vehicle' s
seat back is adjustable, ensure it is in the upright position.
2. Extend the ISO FIX release handle (M) by pushing the ISOFIX adjustment handle (K) and extending the sliders
3. Insert the ISOFIX connectors (K) to the ISOFIX connection point in the car. Make sure that there is a "click" sound
and a green indication on both ISOFIX indicators (G).
4. Push the child car seat towards the vehicle seat back until there is no space between the vehicle seat back and
the child car seat.
IMPORTANT:When the ISOFIX unlock button is displayed in green, the ISOFIX is in the locked state, and when it is
displayed in red, it is in the unlocked state. When unlocking, press and hold the two lock buttons while pulling the
ISOFIX unlocking piece backwards to complete the unlocking.
YES
NO*
YES
NO
NO
NO
ii
i
9