Placing Your Child In The Seat - Axkid Wolmax Bedienungsanleitung

Placing Your Child In The Seat

Before placing your child in the seat, ensure you have adjusted the headrest and harness to the correct height
for your child (see steps 2 To 11)
Press the harness adjuster button (E) and pull forward on the shoulder straps (not the shoulder pads)
26
to completely loosen the harness.
27
Press the red harness release button on the buckle and unfasten the harness.
Place your child in the car seat. Put your child' s arms in between the shoulder straps so that the
28
straps are hanging over the chest and stomach.
29
Pull the shoulder straps together and insert the harness tongues into the crotch buckle.
Pull the harness adjustment strap (F). It' s important that you always pull the harness straight
30
and central when you tighten the adjustment strap. Failure to pull the harness correctly may
cause the strap to jam in the mechanism.
Removing The Child Restraint From The Vehicle
WARNING: Never attempt to remove the child restraint whilst your child is still seated in it.
Open the belt lock-off clips (L) on both sides of the child restraint.
31
Release the vehicle' s seat belt buckle (i) and completely remove the seat belt from the child
restraint. Collapse the support leg (O). Unhook the tether straps' (K) from the child restraint and
remove the child restraint from the vehicle. Finally unwrap the tether straps from the vehicle' s anchor
points and then re-hook the straps on to the child restraint.
8