Honeywell MILLER DuraSeal 1034130-E Allgemeine Hinweise Zur Benutzung Seite 13

3 - GENERAL REQUIREMENTS, WARNINGS AND LIMITATIONS
3-1 GENERAL FALL PROTECTION REQUIREMENTS
All warnings and instructions shall be provided to authorized persons/users.
All authorized persons/users must reference the regulations governing
occupational safety, as well as applicable European standards (EN). Please
refer to product labeling for information on specific EN standards met by
product.
Proper precautions should always be taken to remove any obstructions, debris,
material, or other recognized hazards from the work area that could cause injuries
or interfere with the operation of the system.
All equipment must be inspected before each use according to the manufacturer's
instructions.
All equipment should be inspected by a qualified person on a regular basis.
To minimize the potential for accidental disengagement, a competent person
must ensure system compatibility.
Equipment must not be altered in any way. Repairs must be performed only by
the manufacturer, or persons or entities authorized in writing by the manufacturer,
with the exception of the field the field replaceable lifeline made by a competent
person.
Any product exhibiting deformities, unusual wear, or deterioration must be
immediately discarded.
Any equipment subject to a fall must be removed from service.
The authorized person/user shall have a rescue plan and the means at hand to
implement it when using this equipment.
Never use fall protection equipment for purposes other than those for which it was
designed. Fall protection equipment should never be used for towing or hoisting.
Environmental hazards should be considered when selecting fall protection
equipment. Equipment must not be exposed to environmental hazards and
chemicals which may produce a harmful effect. Use in a corrosive or caustic
environment dictates a more frequent inspection and servicing program to ensure
the integrity of the device is maintained.
Do not allow equipment to come in contact with anything that will damage it
including, but not limited to, sharp, abrasive, rough or high- temperature surfaces,
welding, heat sources, electrical hazards, or moving machinery.
Do not expose the equipment to any hazard which it is not designed to withstand.
Consult the manufacturer in cases of doubt.
Always check for obstructions below the work area to make sure potential fall path
is clear.
Allow adequate fall clearance below the work surface.
Never remove product labels, which include important warnings and information
forthe authorized person/user.
IF THE PRODUCT IS SOLD OUTSIDE THE FIRST COUNTRY OF DESTINATION,
FOR THE SAFETY OF THE USER, THE DEALER MUST ENSURE THAT THE
PRODUCT IS COMPLIANT WITH THE LAWS APPLICABLE IN THAT COUNTRY
AND PROVIDE INSTRUCTIONS FOR THE PRODUCT IN THE APPROPRIATE
13