Scope Of Delivery; Transport; Functional Description - Abicor Binzel FES-200 Betriebsanleitung

4 Scope of delivery

4 Scope of delivery
• Fume extraction system with mains connection of 115/230V
• Rubber connector
• Start-stop pliers with cable and plug (option)
Tab. 5
Order the equipment parts and wear parts separately. Order data and ID numbers for the equipment parts
and wear parts can be found in the current ABICOR BINZEL spare parts and wear parts lists. The contact
for consulting and ordering can be found on the Internet at www.binzel-abicor.com.

4.1 Transport

The scope of delivery is carefully checked and packaged, however damage may occur during shipping.
Make sure that the shipment is complete by referring to the delivery note!
Checking procedure
on receipt of goods
Check the delivery for damage (visual inspection)!
In case of damage
If the delivery has been damaged during transport, contact the last carrier immediately! Keep the
In case of complaints
packaging for possible checks by the carrier.
Use the original packaging and the original packaging material. If you have questions concerning the
Packaging for return
shipment packaging and safety during shipment, please consult your supplier.
Transport
Tab. 6

5 Functional description

• Before putting into operation, it must be checked if the operating voltage given on the nameplate
• Provide sufficient ventilation during operation of the fume extraction system FES-200.
NOTE
The device is equipped with a safety device to monitor the minimum air volume flow to be extracted. A
manometer is used for monitoring. The point at which the minimum volume flow is reached is marked on
the dial scale. If the manometer indicates a higher vacuum (>180mbar), the filter must be cleaned.
Harmful fumes are produced during the welding process. This welding fume can be captured and filtered
by an extraction torch with welding fume filter. The filtered air is led back to the work area.
The FES-200 captures the welding fume with high vacuum directly on the source. Thanks to the permanent
filter cartridge that can be cleaned, the particles are collected in the dust collecting drawer and can then be
emptied and eliminated in the dust collecting bag.
The FES-200 can be equipped with an automatic Start-Stop system. Use the start-stop pliers to switch on
automatically the fume extraction system by fixing it to the cable assembly of the welding device.
 See 6 Putting into operation on page EN-9
The rotary switch (2) (see 7 Operation on page EN-13) is used to switch on and off the device.
EN - 6
Scope of delivery
CAUTION
corresponds to the mains voltage.
FES-200
• Extraction hose (l=5.00 m)
• Dust collecting bag (10 pieces)