Operation - Cameo NANO ROLL 100 Bedienungsanleitung

OPERATION

A few seconds after connecting to the mains, the spotlight is ready for operation and the previously selected operating mode is activated.
CONFIGURE DMX START ADDRESS
Press MODE repeatedly until "Addr" appears in the display. Now press ENTER and while all four characters are flashing in the display, the DMX
start address can be configured as required using UP and DOWN (A001 - A512). Confirm your entry by pressing ENTER. For synchronous control
of several lamps of the same model with a DMX controller (e.g. DMX console), configure the lights with an identical DMX start address and the
same DMX mode setting using DMX cables.
-> ENTER -> UP/DOWN
CONFIGURE MODE
Press MODE repeatedly until "MOdE" appears in the display. Now press ENTER and select the desired mode using UP and DOWN as required
(DMX 2Ch, 8Ch, 10Ch, SLAv, AUtO, SOUn). Confirm your entry by pressing ENTER. Tables with the channel assignment of the different DMX
modes can be found in these instructions under DMX CONTROL.
-> ENTER ->
UP/DOWN
SLAVE MODE
Once you have selected slave mode as described under CONFIGURE MODE, confirm the selection by pressing ENTER. Connect the slave and
the master units (same model) using a DMX cable, and enable one of the standalone modes on the master unit (AUTO, SOUND). The slave
unit will now follow the master unit.
AUTOMATIC CONTROL MODE (AUTO)
Select one of the 17 different auto programmes (AU00 - AU16) and configure the programme running speed (SP00 - SP99). Once you have
selected automatic control as described under CONFIGURE MODE, confirm the selection by pressing ENTER. The characters in the display
will begin to flash and you can select the desired programme using UP and DOWN. Confirm by pressing ENTER. You can now adjust the
programme running speed as required from 0 to 99 using UP and DOWN. (0= minimum, 99 = maximum speed). Confirm with ENTER. If no
further commands are entered, the flashing stops after approx. 10 seconds and the programme number is displayed.
-> ENTER -> UP/DOWN
SOUND CONTROL MODE
Activate sound control mode as described to control the spotlight via the built-in microphone (bass impulses). Select one of the 17 different
sound programmes (SO00 – SO16) and set the microphone sensitivity as required (SE 0 – SE99). Once you have selected sound control as
described under CONFIGURE MODE, confirm the selection by pressing ENTER. The characters in the display will begin to flash and you can
select the desired programme using UP and DOWN. Confirm by pressing ENTER. You can now adjust microphone sensitivity as required from
0 to 99 using UP and DOWN. (0= minimum, 99 = maximum speed). Confirm by pressing ENTER. If no further commands are entered, the
flashing stops after approx. 10 seconds and the programme number is displayed.
-> ENTER -> UP/DOWN
6
-> ENTER
-
<- MODE
/ /
/ /
-> ENTER ->
-
UP/DOWN
<- MODE
-> ENTER ->
-
UP/DOWN
<- MODE
/
-> ENTER
<- MODE
-
-
-> ENTER
<- MODE
-> ENTER
<- MODE