Wisepenetration; Wisesteel - Kemppi X5 FastMig Bedienungsanleitung

throughout the power range (short arc, globular arc and spray arc). WiseFusion is compatible with 1-MIG welding pro-
cess.
>> To take WiseFusion into use, go to the control panel's
feature.
>> To adjust the welding power/wire feed speed, in the control panel's
>> To fine tune the heat output while welding, in the control panel's
For more information on Wise products, visit www.kemppi.com.

3.4.3 WisePenetration+

Available with automatic 1-MIG-enabled equipment only.
In standard MIG/MAG welding, changes in stick-out length cause welding current to fluctuate. WisePenetration+
maintains constant welding current by controlling the wire feed speed according to the stick-out length. This
ensures stable and effective penetration and prevents burn through. WisePenetration+ also adjusts the voltage
adaptively, which keeps the arc focused and optimally short. WisePenetration+ enables welding with Reduced Gap
Technolology (RGT) and is compatible with 1-MIG welding process.
>> To take WisePenetration+ into use, go to the control panel's
WisePenetration+ feature.
>> To adjust the welding current while welding, in the control panel's
>> To fine tune the heat output while welding, in the control panel's
For more information on Wise products, visit www.kemppi.com.

3.4.4 WiseSteel

Available with automatic 1-MIG-enabled equipment only.
The WiseSteel function is based on modifying the conventional MIG/MAG arcs to enable higher quality of welds.
WiseSteel improves the arc control, reduces spatter and helps create an optimally-formed weld pool.
>> To take WiseSteel into use, go to the control panel's
ture.
>> To adjust the welding power/wire feed speed while welding, in the control panel's
control knob.
>> To fine tune the heat output while welding, in the control panel's
© Kemppi
Welding parameters view
Home view, turn the left control knob.
Home view, turn the right control knob.
Welding parameters view
Home view, turn the left control knob.
Home view, turn the right control knob.
Welding parameters view
Home view, turn the right control knob.
83
X5 FastMig
Operating manual - EN
and apply the WiseFusion
and apply the
and apply the WiseSteel fea-
Home view, turn the left
1920960 / 2039