Cleaning The Blade-Brake-Clutch Shield; Adjusting The Self-Propel Drive - Toro Recycler 20958 Bedienungsanleitung

Cleaning the
Blade-Brake-Clutch Shield
Service Interval: Every 25 hours
Clean the blade-brake-clutch shield yearly to prevent
the blade from stalling while you mow.
1. Disconnect the spark-plug wire from the spark
plug; refer to Preparing for Maintenance (page
17).
2. Tip the machine onto its side with the dipstick
down.
3. Remove the 2 blade nuts and the stiffener
(Figure 32).
Figure 32
1. Blade nuts
2. Stiffener
3. Blade
4. Remove the blade
5. Remove the blade driver and disk
6. Remove the blade-brake-clutch shield
32).
7. Brush or blow out debris from the inside of the
shield and around all the parts.
8. Install the blade-brake-clutch shield that you
previously removed.
9. Install the blade driver and disk that you
previously removed.
10. Install the blade and the stiffener that you
previously removed
11. Install the blade nuts and torque them to 20 to
37 N∙m (15 to 27 ft-lb).
4. Blade driver
5. Disk
6. Blade-brake-clutch shield
(Figure 32).
(Figure
(Figure
(Figure 32).
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. Turn the adjustment knob counterclockwise to
loosen the cable adjustment
1. Handle (left side)
2. Adjustment knob
g003133
3. Self-propel-drive cable
2. Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Note:
32).
increase the traction; pull the cable away from
the engine to decrease the traction.
3. Turn the adjustment knob clockwise to tighten
the cable adjustment.
Note:
20
(Figure
Figure 33
4. Turn the knob clockwise to
tighten the adjustment.
5. Turn the knob
counterclockwise to
loosen the adjustment.
Push the cable toward the engine to
Tighten the knob firmly by hand.
33).
g027231
(Figure 33) by