Herunterladen Inhalt Inhalt Diese Seite drucken

Filling The Fuel Tank; Checking The Engine-Oil Level - Toro Recycler 20958 Bedienungsanleitung

55 cm
Vorschau ausblenden Andere Handbücher für Recycler 20958:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

– Avoid prolonged breathing of vapors.
– Keep your hands and face away from the
nozzle and the fuel-tank opening.
– Keep fuel away from your eyes and skin.

Filling the Fuel Tank

For best results, use only clean, fresh, unleaded
gasoline with an octane rating of 87 or higher
((R+M)/2 rating method).
Oxygenated fuel with up to 10% ethanol or 15%
MTBE by volume is acceptable.
Do not use ethanol blends of gasoline, such
as E15 or E85, with more than 10% ethanol by
volume. Performance problems and/or engine
damage may result, which may not be covered
under warranty.
Do not use gasoline containing methanol.
Do not store fuel either in the fuel tank or in fuel
containers over the winter unless fuel stabilizer
has been added to the fuel.
Do not add oil to gasoline.
Fill the fuel tank with fresh unleaded regular gasoline
from a major name-brand service station
Important:
To reduce starting problems, add
fuel stabilizer to the gasoline all season. Mix the
stabilizer with gasoline less than 30 days old.
Refer to your engine owner's manual for additional
information.
Figure 10
Checking the Engine-Oil
Level
Service Interval: Before each use or daily
1.
Move the machine to a level surface.
2.
Remove the dipstick by rotating the cap
counterclockwise and pulling it out
(Figure
10).
1. Full
2. High
3.
Wipe the dipstick clean with a clean cloth.
4.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
5.
Read the oil level on the dipstick
g230458
Important:
low or too high and you run the engine, you
may damage the engine.
6.
Install the dipstick into the oil-fill tube securely.
9
Figure 11
3. Add
If the oil level on the dipstick is too low
(Figure
11), carefully pour a small amount
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps
3
through
5
until the oil on the dipstick
is at the correct level. For the oil type, refer
to
Changing the Engine Oil (page
If the oil level on the dipstick is too high
(Figure
11), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page
If the oil level in the engine is too
(Figure
11).
g244276
(Figure
11).
18).
18).

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis