Cleaning Under The Machine - Toro Recycler 20958 Bedienungsanleitung

Cleaning under the Machine

Service Interval: Before each use or daily
For best results, clean the machine soon after you
have completed mowing.
1. Move the machine onto a flat paved surface.
2. Shut off the engine and wait for all moving parts
to stop before leaving the operating position.
3. Lower the machine to its lowest cutting-height
setting; refer to Adjusting the Cutting Height
(page 10).
4. Wash out the area under the rear deflector
where the clippings go from the housing to the
grass bag.
Note:
Wash out the area with the
bag-on-demand in both the fully forward and
fully rearward positions.
5. Attach a garden hose that is connected to a
water supply to the washout port
Figure 34
1. Washout port
6. Turn the water on.
7. Start the engine and run it until there are no more
clippings that come out from under the machine.
8. Shut off the engine.
9. Shut off the water and disconnect the garden
hose from the machine.
10. Start the engine and run it for a few minutes to
dry the housing to prevent it from rusting.
11. Allow the engine to cool before storing the
machine in an enclosed area.
(Figure 34).
g033492
21