Folding The Handle - Toro Recycler 20958 Bedienungsanleitung

6. Turn the water on.
7. Start the engine and run it until the clippings no
longer come out from under the machine.
8. Shut off the engine.
9. Shut off the water and disconnect the garden
hose from the machine.
10. Start the engine and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
11. Shut off the engine and allow it to cool before
storing the machine in an enclosed area.

Folding the Handle

WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove and save the 2 handle knobs and 2
carriage bolts from the handle brackets
24).
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
1. Handle knob
2. Fold the handle by rotating it forward
Figure 24
2. Carriage bolt
(Figure
1. Operating position
3. Insert the carriage bolt (with the bolt head toward
the inside) through the handle bracket and the
upper hole in the handle end. Ensure that the
square edges of each carriage bolt fits into the
upper or lower square hole in its related handle
bracket
(Figure
1. Handle knob
4. Loosely install the handle knobs and carriage
bolts on the handle brackets.
5. To unfold the handle, refer to
Unfolding the Handle (page
g032869
25).
16
Figure 25
2. Folded position
(Figure 26).
Figure 26
2. Carriage bolt
1 Assembling and
5).
g036582
g032865