Recycling The Clippings; Bagging The Clippings; Operating The Bag-On-Demand Lever - Toro Recycler 20958 Bedienungsanleitung

2. Set all 4 wheels to the 83 mm (3-1/4 inch)
cutting-height setting.
3. Take a half sheet of newspaper and crumple it
into a ball small enough to go under the machine
housing (about 76 mm or 3 inches in diameter).
4. Place the newspaper ball about 13 cm (5 inches)
in front of the machine.
5. Start the engine.
6. Engage the blade.
7. Release the blade-control bar.
8. Immediately push the machine over the
newspaper ball.
9. Shut off the engine and wait for all moving parts
to stop.
10. Go to the front of the machine and check the
newspaper ball.
Note:
If the newspaper ball did not go under
the machine, repeat steps
11. If the newspaper is unravelled or shredded, the
blade did not stop properly, which could result
in an unsafe operating condition. Contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page
the side-discharge chute is on the machine, remove
it; refer to Removing the Side-Discharge Chute (page
14).

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove
it; refer to Removing the Side-Discharge Chute (page
14). If the bag-on-demand lever is in the recycling
position, move it to the bagging position; refer to
Operating the Bag-on-Demand Lever (page
4 through 10.
13). If
13).
13
Installing the Grass Bag
1. Raise and hold up the rear deflector
Figure 19
1. Rear deflector
2. Notches (2)
2. Install the grass bag, ensuring that the pins on
the bag rest in the notches on the handle
19).
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
Grass Bag (page 13).
Operating the
Bag-on-Demand Lever
The bag-on-demand feature allows you to either
collect or recycle grass and leaf clippings while the
grass bag is attached to the machine.
•
To bag the grass and leaf clippings, press the
button on the bag-on-demand lever and move the
lever forward until the button on the lever pops up
(Figure 20).
(Figure 19).
g036580
3. Grass-bag pin (2)
(Figure
Installing the