Cleaning The Blade-Stop System Shield; Storage; Preparing The Machine For Storage; Removing The Machine From Storage - Toro 20897 Bedienungsanleitung

Cleaning the Blade-Stop
System Shield
Service Interval: Every 25 hours
1. Disconnect the spark-plug wire from the spark
plug; refer to Preparing for Maintenance (page
18).
2. Tip the machine onto its side with the dipstick
down.
3. Remove the 2 blade nuts and the stiffener
(Figure 52).
Figure 52
1. Blade nuts
2. Stiffener
3. Blade
4. Remove the blade
5. Remove the blade driver and the anti-scalp disk
(Figure 52).
6. Remove the blade-stop system shield
52).
7. Brush or blow out debris from the inside of the
shield and around all the parts.
8. Install the blade-stop system shield that you
previously removed.
9. Install the blade driver and anti-scalp disk that
you previously removed.
10. Install the blade and the stiffener with the 2 blade
nuts that you previously removed
11. Install the blade nuts.
Note:
Torque the blade nuts to 20 to 37 N∙m
(15 to 27 ft-lb).
4. Blade driver
5. Anti-scalp disk
6. Blade-stop system shield
(Figure 52).
(Figure
(Figure

Storage

Store the machine in a cool, clean, dry place.
Preparing the Machine for
Storage
1. On the last refueling of the year, add fuel
stabilizer (such as Toro Premium Fuel
Treatment) to the fuel as directed on the label.
2. Dispose of any unused fuel properly. Recycle
it according to local codes or use it in your
automobile.
Note:
cause of hard starting. Do not store fuel without
fuel stabilizer more than 30 days, and do not
store stabilized fuel more than 90 days.
3. Run the machine until the engine shuts off from
running out of fuel.
4. Start the engine again and allow it to run until
it shuts off. When you can no longer start the
engine, it is sufficiently dry.
5. Disconnect the wire from the spark plug and
g003133
connect the wire to the retaining post (if
equipped).
6. Remove the spark plug, add 30 ml (1 fl oz) of
engine oil through the spark-plug hole, and pull
the starter rope slowly several times to distribute
oil throughout the cylinder to prevent cylinder
corrosion during the off-season.
7. Loosely install the spark plug.
8. Tighten all nuts, bolts, and screws.
Removing the Machine
from Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine
rapidly by pulling the recoil-start handle to blow
the excess oil from the cylinder.
3. Install the spark plug and tighten it with a torque
52).
wrench to 20 N∙m (15 ft-lb).
4. Perform any maintenance procedures; refer to
Maintenance (page
5. Check the engine-oil level; refer to
Engine-Oil Level (page
6. Fill the fuel tank with fresh fuel; refer to
Safety (page
7. Connect the wire to the spark plug.
22
Old fuel in the fuel tank is the leading
18).
9).
8).
Checking the
Fuel